Author Topic: iR-ADV 8095 E061  (Read 20 times)

steve

  • Global Moderator
  • Newbie
  • *****
  • Posts: 0
iR-ADV 8095 E061
« on: January 05, 2018, 07:12:21 PM »
iR-ADV 8095 E061

Getting an E061-0101
 
Replaced drum blade, primary corona, pre-transfer corona, cleaned slit glass.
 
Machine was used, purchased through some...
Getting an E061-0101



Replaced drum blade, primary corona, pre-transfer corona, cleaned slit glass.



Machine was used, purchased through some re-seller and delivered to customer. He bought two of them, both approx 400-500k.



No real issues with machines, other than the fact that one of them conveniently had potential control disabled in service mode. Only noticed after I started digging to find the solution to a problem where customer was getting darker image on one side of prints.



This guy only prints 11x17 colored paper. He prints about 60k a month. Machine is used for one day a week to run off a newsletter on 11x17 duplex.



Am I right in assuming I should maybe replace the potential control assembly here? Looks like the re-seller wasn't honest about it working 100% before we received it.



I replaced the coronas two weeks ago - no run over xmas break. I put potential control back on, everything seemed normal. He calls me yesterday saying code is on machine again. I walked him through how to turn off potential control in service, now he's getting the dark area. Sometimes it will lessen if you run wire-clean.



Something weird happening.



I would swap entire AP-kit w/ from the other unit on site, but it is typically in use while I am there looking at the other machine.



Drum appears to be original to machine - beginning to wonder if time in storage + age has deteriorated the drum now that he is running it all in one shot with a fair amount of coverage.





This guy has no cell service in front of his machines and he's 30 minutes out of town, only runs the machine once a week lol


Source: iR-ADV 8095 E061

 
Sitemap 1 2 3 4